What We Fix
Premium dishwashers are quiet, efficient, and built around tight-tolerance pumps and sensors, which is exactly why they need a technician who knows them when something goes wrong. We service fully integrated and panel-ready dishwashers from Miele, Bosch, Cove, Thermador, Gaggenau, and KitchenAid, including the G-series Miele units, Bosch 500 and 800 series, and Cove dishwashers built to pair with Sub-Zero and Wolf kitchens.
Whether the unit leaves standing water, leaks onto the floor, stops mid-cycle, or shows an error code, we trace the fault to the pump, valve, sensor, or control and give you a written estimate first.
Common Problems We See
- Standing water in the bottom after a cycle
- Water leaking from the door or pooling under the unit
- Cycle that stalls partway or will not start
- Dishes coming out wet or poorly cleaned
- Error code on the display or blinking lights
- Detergent door that will not open during the cycle
- Door that drops open or will not latch on a panel-ready unit
Typical Causes
Poor drainage usually comes down to a clogged filter or sump, a blocked or kinked drain hose, or a failed drain pump. Leaks trace to a worn door gasket, a cracked spray arm bearing, or a loose hose clamp. A cycle that stalls often means a water inlet fault, a heater circuit problem, or a control that has faulted. Wet dishes generally point to an empty rinse-aid reservoir, a vent that will not open, or a heating element issue, depending on the drying system the model uses.
Brands We Service
We repair dishwashers from Miele, Bosch, Cove, Thermador, Gaggenau, KitchenAid, and Jenn-Air.
Quick Symptom Reference
| Symptom | Likely Cause | What We Do |
|---|---|---|
| Standing water | Clogged filter or drain pump | Clear path, replace pump |
| Leaking | Door gasket or spray arm bearing | Replace gasket or bearing |
| Stalls mid-cycle | Inlet valve or control fault | Test valve, repair control |
| Dishes wet | Rinse aid, vent, or heater | Diagnose drying system |
| Error code | Sensor or pump fault | Read code, fix root cause |
Shut the Water If It Is Leaking
If a dishwasher is leaking onto the floor, close the supply valve under the sink and stop the cycle. Standing water in the tub is normal to leave for a technician, but a running leak can reach cabinets and flooring quickly.
Book a Dishwasher Diagnosis
Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.