What We Fix
Cooktops come in three very different families, and we service all of them. Induction cooktops rely on coils and power boards, sealed-gas cooktops rely on spark ignition, and radiant electric cooktops rely on elements under glass. We repair Wolf induction, gas, and electric cooktops along with units from Thermador, Gaggenau, Miele, Bosch, Dacor, and Jenn-Air, including transitional and modular designs.
Whether a single zone has gone dead, a burner clicks without lighting, or the whole surface shuts off with a fault code, we diagnose the actual failure rather than replacing the entire cooktop on a guess.
Common Problems We See
- Induction zone that will not power or recognize cookware
- Gas burner clicking without lighting, or one burner dead
- Radiant element that stays cold or will not cycle off
- Touch controls that are unresponsive or lock out
- Fault code or flashing display on an induction surface
- Cracked or chipped glass surface
- Cooktop that trips the breaker when a zone is used
Typical Causes
On induction, a dead zone usually traces to a failed coil, a power board fault, or a control ribbon that has lost connection. On gas, a burner that clicks without lighting typically has a dirty igniter or a clogged port, while no click points to a failed spark module or switch. On radiant electric, a cold zone usually means a burned-out element or its infinite switch. A cooktop that trips the breaker often has a shorted element or coil that needs isolating and replacing.
Brands We Service
We repair cooktops from Wolf, Thermador, Gaggenau, Miele, Bosch, Dacor, and Jenn-Air.
Quick Symptom Reference
| Symptom | Likely Cause | What We Do |
|---|---|---|
| Induction zone dead | Coil or power board | Test and replace coil or board |
| Gas burner clicks, no flame | Dirty igniter or clogged port | Clean, clear, or replace igniter |
| Electric zone cold | Element or infinite switch | Replace element or switch |
| Controls locked | Control lock or board fault | Reset, repair control board |
| Trips breaker | Shorted element or coil | Isolate and replace part |
Stop Using a Cracked Induction Surface
A cracked glass cooktop can expose live components and moisture paths. Turn it off at the breaker and avoid using it until the surface is replaced. Do not run water or spills near a chipped edge.
Book a Cooktop Diagnosis
Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.